Thermostat Installation and HVAC Controls for Utah Homes
Serving the Wasatch Front and beyond
We match every thermostat to the equipment, whether single-stage, two-stage, variable-speed, heat pump, or dual-fuel. Wiring is checked at the furnace or air handler, and we configure the thermostat at the install, setting the schedule with you. For homes needing separate temperature zones, we install zoning dampers and controls; for dual-fuel systems, we set the switchover. And you receive a flat-rate price in writing before any work begins.
Book Your Thermostat Installation
Quick answer
Yes, Blue Best installs and sets up smart and programmable thermostats for homes across Utah, the Wasatch Front and beyond. We match the thermostat to the equipment, including single-stage, two-stage, variable-speed, heat pump, and dual-fuel systems. Compatibility with the heating and cooling system is verified per the ENERGY STAR program. Wiring is checked at the furnace or air handler. The thermostat is configured at the install, and we set the schedule with you. Zoning dampers and controls are installed, and the dual-fuel switchover is set. You receive a flat-rate price in writing before work begins.
How can you tell the thermostat or controls need attention?
Rooms never match
You set the temperature but some rooms stay too warm or too cold. We check the thermostat location and calibration.
System short-cycles
Your system turns on and off too often. We check the wiring and thermostat settings to find the cause.
Blank or flickering screen
The display is dark or flashes. We check the power supply and connections at the thermostat.
Unused schedule
The programmed schedule does not match your daily routine. We check the settings and show you how to adjust them.
New heat pump, old thermostat
You installed a new heat pump but kept the old thermostat. We check if the thermostat can communicate with the new equipment.
Upstairs hot, downstairs cold
The temperature differs between floors. We check whether zoning controls could balance the airflow.
Thermostat near a window
The thermostat is mounted where sunlight or drafts reach it. We check the location and suggest a better spot.
Old manual dial
The previous owner left a manual thermostat. We check if a programmable model would fit your system.
Phone control wanted
You want to adjust the temperature from your phone. We check your system's compatibility and explain the options.
Why does your thermostat have to match the equipment?
Nearly half of home energy goes to heating and cooling. Salt Lake City airport records 5,154 heating degree days and 1,420 cooling degree days. Compatibility with the heating and cooling system matters. High-efficiency equipment may need a matching thermostat. A heat pump requires a thermostat built for heat pumps.
Certified accuracy
Connected thermostats that are certified are independently certified on field data. Accuracy is within ±2.0°F. The thermostat works locally without a network. You view and adjust the set temperature. You switch off, heat, or cool. Line-voltage thermostats are excluded. Baseboard heat uses them.[1]
Equipment types
The thermostat must identify the equipment type. Single-stage heat pump with electric backup, two-stage, and variable-speed exist. One thermostat works for single-stage non-communicating equipment. Another works for multi-stage. A communicating thermostat is for the advanced line. A heat pump needs a thermostat built for heat pumps.[2]
Placement rules
Place it away from registers, appliances, lighting, doorways, fireplaces, skylights, windows, direct sunlight, or drafts. Control board pins and switches must be set for the application.[3]
Setback and warranty
Resist overriding the program. Use a hold setting for vacations. Return air below 60°F or 55°F in overnight setback is excluded from coverage. Zoning control battery is replaced yearly.[4]
[1] ENERGY STAR - connected thermostats (certification criteria and guidance). [2] ENERGY STAR - heating and cooling maintenance checklist. [3] ANSI/ACCA 4 QM – 2019 (R2024), Maintenance of Residential HVAC Systems. [4] Lennox - residential warranty and product guidance. [5] Full source list: data-sources
We match the thermostat to the equipment, not to a brand. Wiring is checked first. It is configured at the install. The schedule is set with you. You are walked through the app. We offer a free second opinion on any competitor's quote.
Which control setup fits your home?
Here is how the main thermostat and zoning options compare for a Wasatch Front home.
Programmable thermostat
- ✓Best for: Homes with a consistent daily schedule.
- ✓Schedules by day and hour in any variation, including 7-day, 5+2-day, and 5-1-1 programs
Connected (smart) thermostat
- ✓Best for: Homeowners who want remote adjustments.
- ✓ENERGY STAR certified on field data; local control works without a network
Zoning with a thermostat per zone
- ✓Best for: Homes with uneven temperatures between floors or rooms.
- ✓Uses motorized dampers in the ducts for up to four zones; dampers and bypass tested at maintenance
What you get with a thermostat install
Matched to your equipment
We match the thermostat to your system, whether it is single-stage, two-stage, variable-speed, heat pump, or dual-fuel.
Wiring checked
Wiring is checked at the furnace or air handler, and the thermostat is configured at the install.
Schedule set with you
We set the schedule with you and walk you through the app or the buttons.
Recognition & accreditation
Financing available on qualifying installations, subject to credit approval; ask when you call.
Locally and women-owned and operated meet the owners Google Business Profile.
What our standard inclusions cover
Flat-rate price
You'll receive a flat-rate price in writing before any work begins.
Licensed contractor
We are a licensed Utah contractor with W-2 employees and no subcontractors.
Zoning dampers
We install zoning dampers and controls when your system requires them.
Dual-fuel switchover
We set the dual-fuel switchover for your system.
Rebate paperwork
We file utility rebate paperwork where a program applies.
Workmanship guarantee
Our workmanship guarantee and a free second opinion on any competitor's quote are included.
What happens after you call us?
Step 1
We respond.
We return your call or online form, and same-day is usually available, subject to scheduling.
Step 2
We check your system.
We inspect the wiring at the furnace or air handler, identify whether you have a single-stage or two-stage system, and note if you have a heat pump or dual-fuel setup.
Step 3
We give a written price.
You receive a flat-rate price in writing before any work begins, with the thermostat named and your approval required before we proceed.
Step 4
We install the thermostat.
We place it per the ENERGY STAR program's guidance, set the control board switches for the application per the industry maintenance standard, and configure it for your equipment.
Step 5
We set it up with you.
We set the schedule with you, walk through the app or the buttons, and file utility rebate paperwork where a program applies.
Not sure your thermostat fits your system?
We check the wiring and the equipment type first. If the thermostat fits, we install and configure it. If it does not, we tell you. The price is in writing before any work begins.
What does a properly set up thermostat give you?
Certified models
We install ENERGY STAR certified models where a program requires one. The ENERGY STAR program certifies models independently based on field data.
Right equipment type
The correct equipment type is set at installation. A heat pump with backup heat is identified. Two-stage or variable-speed equipment is identified.
Good placement
The ENERGY STAR guide says to place a thermostat away from drafts and away from sun. We move a badly placed thermostat.
A schedule that fits your life
The ENERGY STAR guide describes the hold setting for time away. We set the schedule with you.
Zoning
The Lennox lineup includes zoning dampers for up to four zones. Each zone gets a thermostat.
Dual-fuel control
A dual-fuel system uses a heat pump and gas furnace. They alternate by outdoor temperature and thermostat setting. We set the switchover.
What thermostat and control problems do we fix?
Wrong equipment type
The thermostat must identify the equipment type. A heat pump with backup heat needs to be set correctly. We match the thermostat to the equipment. If the thermostat cannot be set correctly, we replace it.
Heat pump on wrong control
A heat pump requires a thermostat built for it. We install one matched to the heat pump. The thermostat must control the backup heat properly. We configure the thermostat at the install.
Blank screen
The wiring at the furnace or air handler may be loose. The industry maintenance standard requires the thermostat tested in all modes at maintenance. We trace and repair the wiring. We check the wiring at every tune-up.
Bad placement
The ENERGY STAR guide says to place the thermostat away from registers, sunlight, and drafts. We relocate it to a proper location. We check the placement during installation. A walkthrough confirms the location works.
Zoning that does not zone
The industry maintenance standard requires dampers, valves, and bypass tested. The standard also requires the zoning battery checked yearly. We repair or replace the zone controls. We install zoning dampers and controls.
Dual-fuel system that never switches
The outdoor sensor may be faulty. We set the dual-fuel switchover point.
What does a thermostat install cost in Utah?
We price every job as a flat rate, in writing first, with the drivers published. We check the wiring before we quote. Blue Best quotes an exact price in writing before any work begins.
The price drivers are equipment type, the thermostat model, wiring, and zoning. We also offer a free second opinion on any competitor's quote.
Quoted upfront
Like-for-like replacement - A direct swap of an old thermostat for a new one of the same type.
Quoted upfront
Smart thermostat install - Full set-up of a smart thermostat, including configuration and scheduling.
Quoted upfront
Heat pump or dual-fuel - A thermostat matched to a heat pump or dual-fuel system.
Quoted upfront
Wiring repair or new run - Fixing damaged wires or running a new wire to the thermostat location.
Quoted upfront
Zoning with dampers - Installing zone dampers and controls for separate temperature areas.
What does Blue Best guarantee in writing?
On new equipment installs
a 1-year labor warranty - extendable for customers on a Blue Best Maintenance Plan - the parts warranty (typically 10 years on qualifying Lennox and Amana equipment) registered for you, and no-lemon coverage on major components like compressors and heat exchangers.
On any quoted work
the price you sign is the price you pay - change orders require your approval before we do the work. Plus a free second opinion on any competitor's replacement quote (no blanket price-match - sometimes our honest answer is "take their deal").
What we won't promise
real-world comfort depends on duct condition, insulation, and infiltration, so we disclose those dependencies rather than guarantee a number. The 5.0 rating from 2,900+ reviews is the audit trail.
Thermostat Questions Answered
It depends. Compatibility depends on your heating and cooling equipment. We identify your equipment type first, including heat pumps with backup heat and two-stage or variable-speed systems. We check the wiring and stages at the furnace or air handler before we begin.
The ENERGY STAR guide recommends placing it away from registers, appliances, lighting, doorways, fireplaces, skylights, windows, direct sunlight, and drafts. If yours is badly placed, we can move it to a better location.
ENERGY STAR certification is based on independently verified field data. Certified models maintain ±2.0°F accuracy and provide local control without a network connection. Line-voltage thermostats are excluded from the program.
A dual-fuel system uses a heat pump and a gas furnace that alternate. The switchover is based on outdoor temperature and the thermostat setting, using an outdoor sensor. We set the switchover point for your system.
Sometimes. We file rebate paperwork where a program applies. Programs vary by utility and equipment. ENERGY STAR certified models are required where a program requires one. Ask when you call.
We check the wiring, place the thermostat, and configure it for your specific equipment. We set the schedule with you and walk you through the app or the buttons. Where a utility rebate program applies, we file the paperwork for you.
Yes. The ENERGY STAR guide suggests resisting the urge to override the program. A hold setting works for time away. Lennox's warranty excludes coverage if return air falls below 60°F, so we set a schedule that respects that limit.
Lennox zoning uses motorized dampers in the ducts for up to four zones. Each zone has its own thermostat. The industry maintenance standard requires dampers and bypass to be tested at maintenance. We install and service zoning.
Yes. The industry standard recommends replacing the zoning control battery yearly. Thermostats should be tested in all modes. We check thermostats at every tune-up.
Terms in Plain English
Connected thermostat
A thermostat that controls your system over a network but also works locally when the network is unavailable.
Programmable thermostat
A thermostat that lets you set different temperatures for different times, with options like 7-day, 5+2-day, or 5-1-1 schedules.
Setback
A lower temperature setting your thermostat uses while you are away or asleep to save energy.
Hold
A constant temperature setting that overrides your schedule, useful for vacations or extended absences.
Equipment type
The kind of heating and cooling system you have, such as single-stage, two-stage, variable-speed, or a heat pump with backup heat.
Zoning
A system that uses motorized dampers and a separate thermostat for each zone to control temperatures in different areas independently.
Dual-fuel switchover
The point where your system alternates between a heat pump and a furnace based on outdoor temperature for efficient operation.
Line-voltage thermostat
A thermostat designed for electric baseboard heat, which is not covered by the certification.
What homeowners say
Elizabeth M
1 week ago
Our experience with Blue Best has been fantastic. Shawn, Carson and Khaing have done any amazing job with fixing our shower and pressure valve, patching the drywall, and installing both a water...
Aaron
2 weeks ago
I have been using these people for three years. Costumer service is outstanding and they were able to give me advice on my issue until they came out in a few weeks. Would recommend, but make sure to...
Marian Young
3 weeks ago
We used Blue Best for many projects in our home (faucet replacement, HVAC, installing manifold, replace steam system, etc). Shawn was knowladgable, courteous, explained everything and cleaned up the...
Jeffery Hansen
1 month ago
Just had Roger Pay, our technician complete sumner service on our new (Heat Pump System). He was courteous and thorough but most important, professional. We had BLUE BEST put in a new heat pump in...
